Blizzard Snowplow 800HD Owner's Manual download pdf (Page 14)

Lit. No. B64090, Rev. 05 14 March 1, 2009

MOLDBOARD & A-FRAME ASSEMBLY

6. Remove the draw latch mount pin, spacer and

cotter pin from the draw latch assembly. By

removing this pin, the inner draw latch plates can

swing free. Remove the inner draw latch plate lift

cylinder mount pin. Position the plates on either

side of the lift/lower cylinder rod and insert the

pin through the plates and cylinder rod. With the

cylinder connected to the inner draw latch plates,

rotate the draw latch assembly toward the draw

latch mount holes on the A-frame. Align the holes

in the outer draw latch plate with those of the inner

draw latch plates and the A-frame.

NOTE: The A-frame latch, located at the rear/

center of the A-frame, should be raised up

to insert the draw latch mount pin. Pull the

A-frame latch pull pin out and rotate the latch

counterclockwise if it is locked into position.

Secure the assembly to the A-frame by replacing

the draw latch mount pin, spacer and cotter pin.

Reset the A-frame latch so the A-frame latch pull

pin locks into place.

3/16" x 2-1/2"

Cotter Pin

Hydraulic

Lift/Lower Cylinder

Inner Draw Latch Plate

Lift Cylinder Mount Pin

3/4" x 2-1/2" or

5/8" x 2-3/8" (760LT only)

Draw Latch Mount Pin

1" x 4-21/32" or

1" x 3-7/8" (760LT only)

Draw Latch Arm Pivot Pin

3/4" x 2-1/2" or

3/4" x 2-3/8" for 760LT only

1" OD x 25/32" ID x 5/8"

Spacer

3/16" x 2-1/2"

Cotter Pin

1/4" x 1-1/2"

Cotter Pin

Draw Pin

1" x 6-1/2" or

1" x 5-5/8" for 760LT only

Clevis Pin

3/4" x 3-41/64" or

3/4" x 3-7/16" for 760LT only

Cap Screw

3/4"-10 x 4-1/2" or

3/4"-10 x 4" for 760LT only

Inner Draw Latch Plate

Outer Draw Latch Plate

A-Frame

Latch Pin

A-Frame

Latch

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Comments to this Manuals

No comments

Blizzard Snowplow 800HD Owner's Manual Page 14

Comments to this Manuals